Copy

Our new Remote Switch is finally here and available.

The Remote Switch is designed for inputs of 2s - 3s packs and capable of delivering 20A, which can be used for any sized Helicopter as well as large Airplanes.  Simply run inline between your rx battery pack and its intended item (rx, voltage regulator, etc) and remotely mount the switch in an easily accessible area and your good to go.  A bright red led mounted on the unit will give visual verification of power status.

You can use our Remote Switch several different ways.  Use the actuator on the side of the board to turn the unit on and off, turn the switch to the on position and use your Spektrum Bind-Plug on the pins.  With the plug inserted on the pins, the unit is off, pull the Plug off and the unit turns on.  Have an old "Pin Flag" setup?  Simply replace the female lead to a male lead and it too can be used to turn the unit on and off.

Our Remote Switch is a "fail-safe" design that fails in the on position and is 100% compatible with our full line of Voltage Regulators.  Unit comes wrapped in clear pvc heatshrink and double-sided tape on the rear.